source: spip-zone/sel/conf/svnserve.conf @ 60907

Last change on this file since 60907 was 60907, checked in by perline@…, 9 years ago
File size: 3.1 KB
Line 
1### This file controls the configuration of the svnserve daemon, if you
2### use it to allow access to this repository.  (If you only allow
3### access through http: and/or file: URLs, then this file is
4### irrelevant.)
5
6### Visit http://subversion.apache.org/ for more information.
7
8[general]
9### The anon-access and auth-access options control access to the
10### repository for unauthenticated (a.k.a. anonymous) users and
11### authenticated users, respectively.
12### Valid values are "write", "read", and "none".
13### Setting the value to "none" prohibits both reading and writing;
14### "read" allows read-only access, and "write" allows complete
15### read/write access to the repository.
16### The sample settings below are the defaults and specify that anonymous
17### users have read-only access to the repository, while authenticated
18### users have read and write access to the repository.
19# anon-access = read
20# auth-access = write
21### The password-db option controls the location of the password
22### database file.  Unless you specify a path starting with a /,
23### the file's location is relative to the directory containing
24### this configuration file.
25### If SASL is enabled (see below), this file will NOT be used.
26### Uncomment the line below to use the default password file.
27# password-db = passwd
28### The authz-db option controls the location of the authorization
29### rules for path-based access control.  Unless you specify a path
30### starting with a /, the file's location is relative to the the
31### directory containing this file.  If you don't specify an
32### authz-db, no path-based access control is done.
33### Uncomment the line below to use the default authorization file.
34# authz-db = authz
35### This option specifies the authentication realm of the repository.
36### If two repositories have the same authentication realm, they should
37### have the same password database, and vice versa.  The default realm
38### is repository's uuid.
39# realm = My First Repository
40### The force-username-case option causes svnserve to case-normalize
41### usernames before comparing them against the authorization rules in the
42### authz-db file configured above.  Valid values are "upper" (to upper-
43### case the usernames), "lower" (to lowercase the usernames), and
44### "none" (to compare usernames as-is without case conversion, which
45### is the default behavior).
46# force-username-case = none
47
48[sasl]
49### This option specifies whether you want to use the Cyrus SASL
50### library for authentication. Default is false.
51### This section will be ignored if svnserve is not built with Cyrus
52### SASL support; to check, run 'svnserve --version' and look for a line
53### reading 'Cyrus SASL authentication is available.'
54# use-sasl = true
55### These options specify the desired strength of the security layer
56### that you want SASL to provide. 0 means no encryption, 1 means
57### integrity-checking only, values larger than 1 are correlated
58### to the effective key length for encryption (e.g. 128 means 128-bit
59### encryption). The values below are the defaults.
60# min-encryption = 0
61# max-encryption = 256
Note: See TracBrowser for help on using the repository browser.